ET SYSTEMS ET500-COMPLEX 12V SLIDING GATE DRIVE

ET SYSTEMS ET500-COMPLEX 12V Sliding Gate Drive

ET Systems ET500-COMPLEX Sliding Gate Drive 12Vdc (230Vac powered) with magnetic reed limit switches, built-in control panel, 2 channel rolling code 433.92 Mhz radio receiver, and battery charger card. 100% Duty Cycle. Speed - 300mm/sec on opening. Maximum gate weight 500kgs.
 

• Off Grid Solar Charge capable thanks to Photovoltaic (PV) Technology
• designed to automate residential / apartment building / commercial sliding gates up to 500Kg's in weight
• Intensive use - 100% duty cycle when connected to 230Vac power source
• Built-in battery charger for power outage backup battery operation
• soft start & soft stop (for smoother operation)
• on-board dual channel rolling code radio receiver for 25 full and 6 pedestrian opening operation via remote controls
• adjustable pedestrian opening and auto close time (for added security)
• adjustable Anti-crush setting (for added safety)
• selectable Auto close & Auto close time
• on-board warning buzzer (indicates motor is operating on battery power only)
• built in buzzer (indicates motor is operating on battery only, because of mains supply power failure)
• courtesy Pillar Light activation and connection available (for added security at night)
• theft deterrent bracket included

Designed and manufactured in South Africa

Technical features	ET500-COMPLEX
Power supply (to control unit) Alternate source of supply is a solar charger	220V, +/-10%, 50Hz
Maximum absorbed current @ 220V AC supply	3A
Motor voltage	12V DC
Maximum starting thrust	< 30kgF set
Maximum  rated running thrust	22kgF set
Gate Speed:   When measured with mains of 230V AC   and battery fully charged and gate running load of 5kgF maximum. Lower load = higher speed. Higher load = lower speed.	18m/min
Duty cycle at rated running thrust	100% on PSU 20% battery backup @running thrust less than 10kgF
Operating temperature range	-10° C ÷ +50° C
Anti-crushing sensing	Electronic
Unit mass	13.3kg (incl. battery & PSU)
Maximum gate length	9m
Maximum gate weight	500kg
Auxiliary output for ancillaries	12V DC at 200mA
Battery charge voltage	13.6V DC

 

PLEASE NOTE: Safety First

The specifications and suggested gate sizes will vary depending upon other variables such as friction of wheels, environmental factors e.g. wind loading, type of cladding and external influences which may assist or degrade the recommended gate sizes.
 
All automation applications require external safety photocell protection / vehicle loop detector and appropriate warning signs and/or devices.

MAINTENANCE: To keep your Automated Gate running smoothly
READ MORE NOW > to learn more on Safety and the Maintenance required to keep your Automated Gate running smoothly.

 

> Download PDF

Brochure	ET500-PLUS.pdf
Manual Release	USER_MANUAL.pdf