TAU S.r.l. 12Vdc electromechanical, Linear Swing Gate Drive with Adjustable Stoppers. No Gate Stops Required. For an open bar style gate leaf up to 4 metres.
Adjustable mechanical stoppers that attach to the lead screw to allow for gate position adjustment when external gate stops are not used
Manual override
Multi-position adjustable mounting bracket
Residential use
Optical encoder technology
Approx. Opening time - 18 sec/90°
Intensive use - 100% duty cycle when connected to 230Vac power source
Controlled by the749MA Diamond series auto-adaptive algorithm Control Unit with the following features
Built-in 3 channel 433.92 Mhz rolling-code radio receiver
Built-in battery charger for power outage back-up battery operation
Electronic obstacle detection and crush prevention. EN 12445-12453 standards
Soft start and soft stop
Multi coloured diagnostic LEDs
Off Grid Solar Charge capable thanks to Photovoltaic (PV) Technology
Technical features
650ARM3000ENC
Power supply (to control unit)
230 V AC (50 Hz)
Motor power supply
18 V DC
Absorption
1.1 A
Absorbed power
120 W
Opening time
90° 18 sec.
Duty cycle
100 %
Max. thrust
2600 N
Operating temperature
-20° C - +55° C
Degree of protection
IP 44
Stroke length
506 mm
PLEASE NOTE: Safety First
All gates should be installed with electric locking for security and to minimise excessive force placed on the Gate Drive(s) if the gate leaf(s) are more than approximately 2.5m wide.
The specifications and suggested gate sizes will vary depending upon other variables such as friction of hinges, environmental factors e.g. wind loading, type of cladding and external influences which may assist or degrade the recommended gate sizes.
All automation applications require external safety photocell protection / vehicle loop detector and appropriate warning signs and/or devices.
MAINTENANCE: To keep your Automated Gate running smoothly READ MORE NOW > to learn more on Safety and the Maintenance required to keep your Automated Gate running smoothly.
TAU 650ARM3000ENC 12V Linear Swing Gate Drive
TAU S.r.l. 12Vdc electromechanical, Linear Swing Gate Drive with Adjustable Stoppers.
No Gate Stops Required. For an open bar style gate leaf up to 4 metres.
Controlled by the 749MA Diamond series auto-adaptive algorithm Control Unit with the following features
PLEASE NOTE: Safety First
All gates should be installed with electric locking for security and to minimise excessive force placed on the Gate Drive(s) if the gate leaf(s) are more than approximately 2.5m wide.
The specifications and suggested gate sizes will vary depending upon other variables such as friction of hinges, environmental factors e.g. wind loading, type of cladding and external influences which may assist or degrade the recommended gate sizes.
All automation applications require external safety photocell protection / vehicle loop detector and appropriate warning signs and/or devices.
MAINTENANCE: To keep your Automated Gate running smoothly
READ MORE NOW > to learn more on Safety and the Maintenance required to keep your Automated Gate running smoothly.
> Downloads